First Section
-
SAFETY FIRST- MUST READ!
-
A list of the equipment that I have used in this course
-
Using dividers to mark the wax (1:53)
-
Cutting and making the sure the wax is a straight ring blank (3:57)
-
Sizing the ring (4:27)
-
Marking the height of the ring (3:48)
-
Marking the width of the ring band (2:50)
-
Reducing down the top (4:26)
-
Measuring and marking in the shape of the signet top (3:20)
-
**How to mark in an alternative shape top** (5:47)
-
Marking in the remainder of your profile to get a complete picture of the ring outlines (7:19)
-
Removing the excess wax and reducing the ring down to just before the marked shape (6:50)
-
A bit of sanding and preparing the surface (9:00)
-
Sanding back the top (1:31)
-
Tapering the band (9:00)
-
A further quick sand over the surface (6:46)
-
Scraping the ring surface (12:26)
-
A little polish on the surface (1:10)
-
A look at the finished ring (0:20)
